Step 1 Enable WiFi on your AGO

Go to Settings → Firmware Update → WiFi Web Server. Use the right arrow to highlight DISABLED, then use UP / DOWN to change it to ENABLED.

Step 2 Check the screen

Confirm the following on your AGO display:

• IP should show a number other than 0.0.0.0
• SSID should display AGO
• PASS is 12345678

If IP stays at 0.0.0.0, go back and make sure WiFi is set to ENABLED.

Step 3 Connect your computer to the AGO network

On your computer, open your WiFi connections and find the network named "AGO". Connect using the password 12345678.

Step 4 Open the AGO interface in your browser

Open any browser (Chrome, Safari, etc.) and type the IP address shown on your AGO screen into the address bar. This is usually 10.10.10.1. Hit enter.

Step 5 Wait for the page to load

Wait until the AGO page has fully loaded in your browser. You are now connected and ready to update firmware or edit programs.