Unable to connect to AGO via Wifi

AGO WiFi Connection Troubleshooting

Connecting to WiFi

Follow these steps to connect your AGO to WiFi:

1. Go to Settings → Firmware Update → WiFi Web Server.
   Use the right arrow to highlight DISABLED and change it to ENABLED with UP / DOWN.
2. Check the screen:
   – IP should show a number format other than 0.0.0.0.
   – SSID should display AGO.
   – PASS is 12345678.
   If IP stays at 0.0.0.0, make sure WiFi is enabled again.
3. On your computer, open WiFi connections and find “AGO”. Connect using PASS 12345678.
4. Open a browser (Chrome, Safari, etc.) and type the IP shown on your AGO screen, usually 10.10.10.1, then hit enter.
5. Wait until the AGO page loads in your browser.